Shopping Cart

Installation

instalacjaThe installation process

The main premise behind the Fibaro System is the possibility to install it in any house, apartment or office building, without damaging the infrastructure. We offer you full control over your house, without the need to damage walls, modify switching stations or exchange switch hardware. It is our system that adjusts to your requirements, and not the other way round. It is one of the many differences which sets us apart from our competitors.


3min3-Minute Installation

The installation of our devices takes about 3 minutes. All you need to do is remove a given switch (e.g. the one responsible for switching the lights on and off) from the wall, disconnect it from the wires coming out of the wall, connect the Fibaro module to the wires and reconnect the switch to the module. Next you need to screw the switch into the wall, and thus complete the process of the physical installation.

rekaMiniaturized Structure

Each Fibaro System module is only 42.5 mm long, 37.0 mm wide and 15.9 mm high, which makes them the world’s smallest devices of this type. Some other advantages of the Fibaro System include neat appearance, reliability and perfection.


Simple and Non-invasive Installation

To ensure your safety, a registered electrician or approved FIBARO installer must install the system. The picture below shows an example of the installation process for one of our products.

instalacja_ilustracja


system_laptop2Adding a Device to the Home Center

In order to complete the installation process, you need to add the installed device to the Home Center, i.e. to our automation center’s database. By putting the Home Center into learning mode and pressing the switch under which our module is located three times, you will complete the installation process. Thanks to the innovative Z-Wave technology, the Fibaro System devices can easily communicate with the Home Center, the installation of the building automation system is easy and – more importantly – cheap.