Fibaro Double Switch 2 – FGS-223

$119.00

The Double Switch 2 can independently control two loads of up to 1.5KW (6.5A) to a total load of 10A all within a tiny device (43 x 38 x 22mm). Use this device to add any off/on device to the system and allow Fibaro to control intelligently.

Found this product at a lower price?
SKU: FGS223
Categories: , ,
Tags: , , , , ,

Share on:

  • Description

Description

The Double Switch 2 can independently control two loads of up to 1.5KW (6.5A) to a total load of 10A all within a tiny device (43 x 38 x 22mm). Use this device to add any off/on device to the system and allow Fibaro to control intelligently.

The Double switch 2 is built on the Z-Wave 500 series chip meaning greater range and reliability plus give real-time energy consumption back to the Home Centre so you can see exactly what you’re spending and where.

Designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. FIBARO Double Switch 2 allows to control connected devices either via the Z-Wave+ network or via a switch connected directly to it and is equipped with active power and energy consumption metering functionality.

Features

  • Compatible with any Z-Wave or Z-Wave+ Controller
  • 2x 1.5Kw Outputs
  • Supports protected mode (Z-Wave network security mode) with AES-128 encryption
  • Advanced microprocessor control
  • Active power and energy metering functionality
  • Works with various types of switches – momentary, toggle three-way, etc
  • To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulation

This device may be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.

FIBARO Switch2 is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize these features.

 

Power Supply: 100-240V~ 50/60 Hz
Rated Load Current:
IEC standards:
6.5A per channel
10A overall
Operating Temperature: 0-35°C
For Installation in boxes: Ø ≥ 50mm, depth ≥ 60mm
Overcurrent protection: required external 10A circuit breaker
Radio Protocol:
Z-Wave
(500 series chip)
 Range:
up to 50m outdoors
up to 40m indoors
(depending on terrain and building
structure)
Radio Frequency: 921.4 MHz
Dimensions (L x W x H): 42.5 x 38.25 x 20.3 mm

 

 

Please note, this device must be installed by a licensed electrician, before contracting an electrician please check that they provide a warranty and electrical compliance certificate.

Double Switch 2 Manual