Fibaro Single Switch 2
Fibaro Single Switch 2

Fibaro Z-Wave Single Switch 2

FGS-213
In Stock
$105.00
Tax included

The Single Switch 2 can control one load of up to 2KW (8A)  within a tiny device (43 x 38 x 22mm). Use this device to add any off/on device to the system and allow Fibaro to control intelligently.

 

Fibaro Single Switch 2

The Fibaro Single Switch 2 can control one load of up to 2KW (8A)  within a tiny device (43 x 38 x 22mm). Use this device to add any off/on device to the system and allow Fibaro to control intelligently. Fibaro built the Single switch 2 on the Z-Wave 500 series chip meaning greater range and reliability plus it gives real-time energy consumption back to the Home Centre. What does it mean? So you can see exactly what you’re spending and where. As a result, it is designed to be installed in standard wall switch boxes or anywhere else where it is necessary to control electric devices. FIBARO Single Switch 2 allows to control connected devices either via the Z-Wave+ network or via a switch connected directly to it and is equipped with active power and energy consumption metering functionality.

Features

  • Compatible with any Z-Wave or Z-Wave+ Controller
  • 1x 2Kw Output
  • Supports protected mode (Z-Wave network security mode) with AES-128 encryption
  • Advanced microprocessor control
  • Active power and energy metering functionality
  • Works with various types of switches – momentary, toggle three-way, etc
  • To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulation
In conclusion, you can use this device with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.
FIBARO Switch2 is a Security Enabled Z-Wave Plus product and a Security Enabled Z-Wave Controller must be used in order to fully utilize these features.
Power Supply: 100-240V~ 50/60 Hz
Rated Load Current:
IEC standards:
8A
Operating Temperature: 0-35°C
For Installation in boxes: Ø ≥ 50mm, depth ≥ 60mm
Overcurrent protection: required external 10A circuit breaker
Radio Protocol:
Z-Wave
(500 series chip)
 Range:
up to 50m outdoors
up to 40m indoors
(depending on terrain and building
structure)
Radio Frequency: 921.4 MHz
Dimensions (L x W x H): 42.5 x 38.25 x 20.3 mm

 

Also please note, a licensed electrician has to install this device. Yet before contracting an electrician please check that they provide a warranty and electrical compliance certificate. Single Switch 2 Manual

Smart Device Type
0
Bulk Pricing
0
Automation System
0
No reviews
Comments (0)
No customer reviews for the moment.
Product added to wishlist